![]() ![]() If the virtual deck is set to INT mode, and is unloaded, the input record level is sent to the Virtual Deck's higher resolution stereo meters. This way you can double check your levels. Drop the needle into a loud part of the track, and record a few seconds, and then shift - arrow to load it on to the virtual deck. Tip: remember that ctrl - n turns recording on and off, and that you can load a recording without saving it using shift arrow. The input select in the set up screen (line or phone) determines whether or not the phono pre amp is used. The file is saved as a 44.1Khz 16bit stereo AIFF file. my documents\my music\scratchlive\recording. The recordings are in the same format and saved to the same place as mic recordings. This boosts or attenuates the input signal up to 12dB. Select one of these, and you'll see a input level adjustment knob appear to the right of the level indicators. If you click on the triangle next to the mic record button, you'll see that you can now select inputs 1 and 2. Shift arrow keys - coarse adjust in/out-point Press the x button to clear the loop slot, or click on the loop number to lock the loop and prevent any further changes. If a loop is set in a given slot, the background (behind the loop number) will be green. There are 9 available loop slots per track. The control vinyl will go back to controlling playback once the record is back up to speed. Once you are happy with the new in-point, click the 'in' button to save, and release the control vinyl. Moving the vinyl will adjust the in-point. Click the 'in' button, and then move the control vinyl. You can also use the control vinyl (or CD) to adjust the in- and out-point. The same applies to adjusting the out-point. Click the in button again to save the in-point. Hold down the shift key while pressing the arrow key to make coarse adjustments. Use the arrow keys - left arrow to move the in-point towards the start of the track, right arrow to move the in-point towards the end of the track. To adjust the in-point of the loop, click the in button. ![]() To force the playhead to jump to the start of the loop when you turn it on, hold down the ctrl key and click the loop button. To enable or disable a loop, click the loop button. To set a loop, set the in-point and the out-point. Scratch Live version 1.5 has looping, sampling from vinyl, a horizontal waveform option, tool tips in multiple languages, instant doubles, support for new Intel based Macs, faster load times, and much more. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |